AL-1410 DIDACTIC UNIT TO STUDY OF THE 3RD & 5TH ORDER HARMONICS GENERATED BY VDS
Project Information
- Category: ELECTRICAL ENGINEERING
- Sub Category: ELECTRICAL ENGINEERING
- Model Number: AL-1410
Description
AL-1410 Didactic Unit To Study Of The 3rd & 5th Order Harmonics
Generated By VDS
Reference: AL-E1410
·
Equipment: Didactic training unit for practical study, measurement and
correction of harmonics generated by a Variable Speed Drive (VSD).
·
VSD: Three-phase industrial VSD suitable for generating and studying
harmonic distortion under controlled operating conditions.
·
Harmonic Study: Dedicated arrangement for analysis of 3rd and 5th
order harmonics produced by the VSD.
·
Commissioning & Operation: Provision
for system start-up, commissioning, parameter setting and practical operation.
·
Harmonic Filtering: Built-in/plug-in filtering arrangement for studying the reduction
of 3rd and 5th harmonic components.
·
Power Factor Study: Measurement and evaluation of power factor before and after
harmonic correction.
·
Practical Correction: Allows learners to apply and
compare harmonic-correction methods and observe their effect on power quality.
·
Measurement: Suitable measurement points/meters for voltage, current, frequency,
harmonic distortion and power factor.
·
Analysis: Harmonic analysis facility for identifying harmonic order and
comparing unfiltered and filtered conditions.
·
Motor Load: Three-phase asynchronous motor/load arrangement suitable for VSD
operation and harmonic generation studies.
·
Controls & Connections: Clearly identified terminals,
control switches and test points for safe practical experiments.
·
Safety: Main isolation, circuit protection, emergency stop, fault
indication and suitable electrical protection for laboratory use.
·
Accessories: Required VSD, harmonic-filter components, measuring instruments,
connecting leads and communication/configuration accessories.
·
Documentation: User manual, experiment manual, wiring diagrams, commissioning
procedure and harmonic measurement/correction instructions.
·
Supplier shall confirm: Exact manufacturer and model;
catalogue/custom status; point-by-point compliance; complete BOM and required
accessories; dimensions, weight, utilities and interfaces; electrical drawings;
safety certificates; capacity and test evidence; delivery and site-support
schedule; assumptions and exclusions.