AL-E360 ELECTRICITY LAB TRAINER (ELT)

AL-E360 ELECTRICITY LAB TRAINER (ELT)

Project Information

  • Category: ELECTRONICS ENGINEERING
  • Sub Category: BREAD BOARD TRAINERS
  • Model Number:
  • Category: ELECTRONICS ENGINEERING

Description

SCOPE OF LEARNING:

  • SERIES COMBINATION OF BULBS.
  • PARALLEL COMBINATION OF BULBS.
  • OPERATION OF RELAY.
  • OPERATION OF DPDT SWITCH.
  • OPERATION OF MAGNETIC COMPASS.
  • STUDY OF BAR MAGNET.
  • STUDY OF ELECTROMAGNETISM THROUGH ELECTROMAGNETIC COILS AND CORES.
  • STUDY OF RESISTOR.
  • STUDY OF CAPACITOR.
  • STUDY OF DIODE.
  • STUDY OF TRANSFORMER.
  • STUDY OF OHM’S LAW.

TECHNICAL SPECIFICATIONS:

  • ONE NUMBER OF AC VOLTMETER: 15V
  • ONE NUMBER OF DC VOLTMETER : 30V
  • ONE NUMBER OF GALVANOMETER: ± 600UA
  • ONE NUMBER OF DC AMPERE METER: 0.5AMP.
  • ONE NUMBER OF DC AMPERE METER: 5A
  • POWER SUPPLIES: POWER SUPPLY: 2- 12V AC/DC AT 3.5A, POWER SUPPLY: 30VDC AT 500A, POWER SUPPLY: 15VDC AT 500MA.
  • ONE NUMBER OF SPDT SWITCH.
  • ONE NUMBER OF DPDT SWITCH.
  • ONE NUMBER OF PUSH SWITCH.
  • TWO NUMBER OF LOGIC SWITCHE.
  • ONE NUMBER OF RELAY 12VDC.
  • ONE NUMBER OF BUZZER/CONTINUITY TESTER.
  • THREE NUMBER OF BULB (6 V, 0.3A).
  • RESISTANCE 1E2/1W, 5E/5W, 50E/5W, 100E/5W, 220E/2W, 470E/2W, 1K/1W, 100K/1W.
  • TWO NUMBER OF CAPACITANCE 1000MFD/50V.
  • TWO NUMBER OF DIODE IN4007.
  • ONE NUMBER OF LED (5MM).
  • ONE NUMBER OF POTENTIOMETER (10K).
  • ONE NUMBER OF BREADBOARD (840 TIE POINTS).
  • ONE NUMBER OF FUSE HOLDERS (OPEN TYPE).
  • ELECTROMAGNETIC INDUCTION&TRANSFORMER.
  • MAIN SUPPLY 230VAC, 50 HZ.

SALIENT FEATURES:

  • Twelve numbers of patch cords/ connecting leads.
  • Three numbers of magnets (two number of bar type, one number of horseshoe (u) type).
  • One number of coil (100 turns) and 200 turns
  • Glass Fuses - 10 nos. 0.5a
  • Compass - 1 no.
  • Core - 1 set of e& i with bolt
  • IC - And (IC 7408), Or (IC 7432), Not (7404) and Ex-or gate (ic7486)
  • Front Panel Built With High Class Insulated Printed Circuit Board Sheet With Well Printed Circuits And      Symbols.
    • Fuse For Short Circuit Protection
    • Instruction Manual.
    • Connections are brought out through 2mm Brass Sockets.
    • Patch Cords 2mm.
    • The trainer is housed in ABS Plastic cabinet.
    • Size of the trainer set 12”x10”

ACCESSORIES:

MULTIMETER - 1 NO.

Technical Details