AL-E448 STEPPER MOTOR CONTROL TRAINER (uController BASED)

AL-E448 STEPPER MOTOR CONTROL TRAINER (uController BASED)

Project Information

  • Category: ELECTRICAL ENGINEERING
  • Sub Category: POWER ELECTRONICS AND DRIVE LAB
  • Model Number:
  • Category: ELECTRICAL ENGINEERING

Description

SCOPE OF LEARNING:

  • Study of Speed  Control  of Stepper Motor by Interfacing uController
  • Fast & slow by assembly language programming
  •  Forward & reverse by assembly language programming
  •  Free run & step by assembly language programming
    • TECHNICAL SPECIFICATIONS:

Power Supply:

  • IC regulated +5V and +12V DC at 1A
  • Operated on Mains power 230V, 50Hz +10%

Components are mounted on the panels are:

  • RS232 Interface using Max232 given on board for interfacing between PC and Trainer.
  • 08. Driver NXP 89V51Rd2
  • Adequate nos. of other electronic components.
  • DC Stepper Motor 6 winding torque 1.0 Kg-cm, step angle 1.8º, power 12V 0.2 Amp/ phase
  • One 16x2 LCD provide on board.
    SALIENT FEATURES:
  • Front panel built with high class insulated Printed Circuit Board sheet with well printed circuits and      symbols.
    • Instruction manual.
    • Connections are brought out through 10 pin FRC Connector.
    • Patch Cords 10pin FRC Female Connector.
    • The trainer is housed in High Class Insulated Plastic cabinet.
    • Size of the trainer set 12”x10”

OPTIONAL ACCESSORIES:

  • No

Technical Details