AL-E160C ANALOG-DIGITAL FIBER OPTIC TRAINER

AL-E160C ANALOG-DIGITAL FIBER OPTIC TRAINER

Project Information

  • Category: ELECTRONICS ENGINEERING
  • Sub Category: FIBER OPTICS TRAINER KITS
  • Model Number:
  • Category: ELECTRONICS ENGINEERING

Description

SCOPE OF LEARNING:

  • Setting up Fiber Optic Analog Link Setting up Fiber Optic Digital Link
  • Study of Intensity Modulation Technique using Analog Input Signal
  • Study of Intensity Modulation Technique using Digital Input Signal
  • Setting up of Propagation Loss in Fiber Optic Study of Bending Loss.
  • Measurement of Optical Power using Optical Power Meter
  • Measurement of Propagation loss using Optical Power Meter
  • Measurement of Numerical Aperture Characteristics of F-O Converter using OPM
  • Characteristics of Fiber Optic communication Link
  • Setting up of Fiber Voice Link using Intensity Mode
  • Study of PC to PC Communication using Fiber Optics Digital Link
  • Frequency Modulation and Demodulation
  • PWM Modulation and Demodulation

TECHNICAL SPECIFICATIONS:

  • Two Transmitter Fiber Optics LED having peak wavelength of emission 660nm & 950nm
  • Two Receiver Fiber Optic photo detector
  • On-board Analog & Digital Drivers.
  • On-board AC Amplifiers.
  • Analog Band Width 350 KHz
  • Digital Band Width 2.5 KHz
  • 4 order Butter worth 3.4KHz Low Pass Filter
  • On-board 10Hz. To 10 KHz sine wave (amplitude adjustable), square wave Selectable.
  • FO voice link using microphone & speaker
  • RS-232C PC to PC Serial Link using 9 pin D-Connector.
  • Fiber Optics Cable Connector type Standard SMA.
  • Duly polished fiber at both end for Numerical Aperture Measurement.
  • Step indexed multimode PMMA plastic cable.
  • Numerical aperture Better than 0.5.
  • Acceptance Angle Better than 60
  • Fiber Diameter 1000 microns.
  • Outer Diameter 2.2mm.
  • Fiber Length 1m and 3m
  • In-Built Power Supply +5V/1.5A, ±12V/250mA.

SALIENT FEATURES:

  • 660nm and 950nm Transmitter.
  • Two Nos. Of Photo Detector.
  • On-board Sine & Square wave generator:10Hz-10KHz
  • On-board 4th Order Low Pass Filer. 2 Nos.
    • In-Built DC Regulated Power Supply.
      • Front Panel Built With High Class Insulated Printed Circuit Board Sheet With Well Printed Circuits And      Symbols.
      • Fuse For Short Circuit Protection
      • Instruction Manual.
      • Connections are brought out through 2mm Brass Sockets.
      • Patch Cords 2mm.
      • The trainer is housed in ABS Plastic cabinet.
      • Size of the trainer set 12”x10”

OPTIONAL ACCESSORIES:

  • CRO
  • OPTICAL POWER METER

Technical Details